Power Supply
Your QY10 Music Sequencer will run either from batteries or an AC adapter — both sold separately. Follow the instructions below according to the power source you intend to use.
• Using Batteries
Six 1.5V AA size (SUM-3 or R6P) or equivalent alkaline batteries (sold separately) must first be installed in the battery compartment.
1. Open the battery compartment cover — located on the instrument's bottom panel — by sliding it in the direction of the arrow.
|
© | ||
|
0 | ||
|
0 | ||
|
k- ..... |
2. Insert the six batteries, being careful to follow the polarity markings inside the compartment. 3. Replace the compartment cover, making sure that it locks firmly in place. When to Replace the Batteries When the batteries run down and are no longer able to operate the QY10, the following display will appear: When this display appears, replace the batteries with a complete set of six new batteries. NEVER mix old and new batteries! To prevent possible damage due to battery leakage, remove the batteries from the instrument if it is not to be used for an extended period of time. • Using An Optional Power Adapter Plug the DC output cable from an optional Yamaha PA-IB or PA-3 AC Adapter into the DC IN 12V 300mA jack on the rear panel, then plug the adapter into a convenient wall AC power socket. Do not attempt to use an AC adapter other than the Yamaha PA-IB or PA-3 to power the QY10. The use of an incompatible adapter may cause irreparable damage to the QY10, and might pose a serious shock hazard! Be sure to unplug the AC adapter from the AC mains socket when the QY10 is not in use. |
Post a comment