Type St
Note 1 Don't use the 12 pin flexible board of CPC-9 jig. It causes damage to the unit. Note 2 The old CPC-9 jig Parts code J-6082-393-B cannot be used, because it cannot operate the adjustment remote commander. Description on Self-diagnosis Display The camera has a self-diagnosis display. This function displays the camera condition with five-digits a combination of a letter and figures on the LCD screen. If this occurs check the following code chart. The five-digits display informs you of the...
Info Hjv
Note 1 Check that the data of page 6, address 02 is 00. If not, turn the power of unit OFF ON. VIDEO OUT of SETUP menu NTSC NTSC mode This adjustment must be performd in NTSC mode, so don't set the menu setting to PAL 1 Place the Flange back adjustment chart 2.0 m from the front of the lens. 2 Check that the center of Flange back adjustment chart meets the center of shot image screen with the zoom lens at TELE end and WIDE end respectively. 3 Check that the data on page F, address 14 to 25, 87...
143574121 141982811
TRANSFORMER, DC-DC CONVERTER COIL, TRIGGER Note Resistor is mounted to the location where FB052 is printed. 5002 1-771-138-61 SWITCH, KEY BOARD FLASH 5003 1-771-138-61 SWITCH, KEY BOARD MACRO 5005 1-771-138-61 SWITCH, KEY BOARD VOLUME 5006 1-771-138-61 SWITCH, KEY BOARD LCD ON OFF 5007 1-771-138-61 SWITCH, KEY BOARD VOLUME - 5008 1-771-138-61 SWITCH, KEY BOARD PROGRAM AE
V
4. Preparing the Flash Adjustment Box A dark room is required to provide an accurate flash adjustment. If it is not available, prepare the flash adjustment box as given below 1 Provide woody board A, B and C of 15 mm thickness. 2 Apply black mat paint to one side of woody board A and B. 3 Attach background paper J-2501-130-A to woody board C. 4 Assemble so that the black sides and the background paper side of woody board A, B and C are internal. Fig 5-1-10 1-2. INITIALIZATION OF B, D, E, F, 7...